Exsanguination Tourniquet for Arm L1700

1.3 Product composition: An elastic silicone ring, an elastic stockinet sleeve, two colored pulling straps, two handles, a binder tie, and a plastic card.

13. Use Method 13.1 Measure the circumference of the hemostatic site of the patient's limbs.Make sure that the circumference of the limb is between 14-85cm.If the measured circumference is beyond the above range, please use other methods to drive hemostasis. 13.2 Open the outer package of the product, take out the product from the inner package according to the aseptic operation procedure in the operating room and put it on the operating table to ensure that the protective card is available at the end of the operation. 13.3 According to the operation position, disinfect to the upper middle arm and upper thigh, and cover the edge of disinfection area with sterile transparent cloth. 13.4 Product installation 13.4.1 Upper limb model product: if the patient is awake, let the patient gather the thumb and four fingers together; if the patient is not awake, the assistant s taff (wearing sterilized gloves) will hold the patient's thumb and other four fingers together; insert the patient's finger tip into the opening of the product and make the handle back to the patient, grasp the two handles close to the patient's arm and pull toward the proximal end.At the same time, another assistant (wearing sterilized gloves) grasps the end of the limb to resist traction, so as to make the product roll towards the proximal end of the arm. 13.4.2 Lower limb model products: the assistant staff (wearing sterilized gloves) insert the patient's toe into the opening of the product and make the handle back to the patient, grasp two handles close to the patient's lower limb and pull to the proximal end. At the same time, another assistant (wearing sterilization gloves) grasps the end of the limb to resist traction, so that the product rolls on the lower limb towards the proximal end. 13.5 Pull the handle until the elastic silicone ring of the product is pulled to the hemostatic position: 10cm proximal to the wrist or mid-arm,5-15cm proximal to the lateral mallelous or mid-thigh.The product should be kept within the disinfection area of limbs. 13.6 Use sterile water for injection or 0.9% sodium chloride injection to infiltrate the elastic sleeve on the surgical site, and then cut it.Wetting the elastic sleeve before cutting can minimize the fabric fragments, and the surgical site can be covered with sterile transparent cloth. 13.7 After the operation, insert the protective card under the elastic silicone ring from the distal end, cut off the elastic silicone ring with a scalpel, cut off the elastic sleeve with scissors and take it off the patient's limb. At this time, the patient's limb recovers blood circulation, and attention should be paid to hemodynamic changes and timely treatment. 14. Storage Condition The product should be placed in a clean room with a relative humidity of no more than 80%RH, no corrosive gas and good ventilation. 15. Transport Condition In the process of transportation, packaging is prohibited from collision and rain. 16. Manufacturing Date and Expiry Date Refer to the manufacturing date and expiry date on the label. 17. Disposal Method The product is disposable, it should be disposed according to the local medical waste disposal regulations if it is out of expiry date or failed to use.

Propylene Glycol, Mannitol, Menthol, Isopropyl Alcohol, Glacial Acetic Acid are our best selling products and welcome to contact us for more information